Uncategorized

2013 Latest Cisco 350-001 Exam Section 5: RIPv2 (10 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 5: RIPv2 (10 Questions) QUESTION NO: 1 Routers TK1 and TK2 are in the same LAN, and both are running RIP version 2. During a troubleshooting session you place a sniffer on the LAN network. Using the sniffer you see routers TK1 and TK2 sending routing updates to each other every 30 seconds. Which IP address should you expect to see these updates destined to? (Choose all that apply) A. 224.0.0.10 B. 255.255.255.255 C. 224.0.0.13 D. 224.0.0.5 E. 224.0.0.9 F. Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 4: Route Filtering and

Ensurepass2013 Latest Cisco 350-001 Exam Section 4: Route Filtering and Policy Routing (5 Questions) QUESTION NO: 1 A router is being configured to override the normal routed behavior of certain traffic types. To do this, Policy Based Routing is used. Which of the following statements is FALSE with regards to the application of policy based routing (PBR)? A. PBR can not be used to set the IP precedence. B. PBR can not set the DSCP in one statement. C. PBR can be used to set the next hop IP address. D. Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 3: EIGRP (19 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 3: EIGRP (19 Questions) QUESTION NO: 1 An EIGRP multicast flow timer is defined as which of the following? A. The timeout timer after which EIGRP retransmits to the neighbor in non CR mode, through unicasts. B. The time interval that EIGRP hello packets are sent. C. The timer after which EIGRP will not forward multicast data traffic. D. The timer interval between consecutive transmitted EIGRP hello intervals. E. The timeout timer after which EIGRP Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 2: General Routing Concepts

Ensurepass2013 Latest Cisco 350-001 Exam Section 2: General Routing Concepts (17 Questions) QUESTION NO: 1 Under the OSPF process of your router's configuration, you type in "redistribute igrp 25 metric 35 subnets" in order to redistribute your OSPF and IGRP routing information. What affect did the "subnets" keyword have in your configuration change? A. It resulted in OSPF recognizing non-classful networks. B. It had no effect since IGRP will summarize class boundaries by default. C. It forced IGRP Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 2: BGP (31 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 2: BGP (31 Questions) QUESTION NO: 1 Which of the following is are considered to be attributes of BGP routes? (Choose all that apply) A. Origin B. Weight C. Local Preference D. Community E. Cluster List Answer: A, C, D, E Explanation: Origin, Local Preference, Community, and Cluster List are all BGP attributes. ORIGIN Well-known mandatory, Type code 1 RFC 1771 LOCAL_PREF Well-Known discretionary, Type code 5 RFC 1771 COMMUNITY Optional transitive, Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 1: OSPF (20 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 1: OSPF (20 Questions) QUESTION NO: 1 Router TK1 is configured for OSPF. Under the OSPF process, you type in the "area 1 range" command. Which LSA types will be acted upon (summarized) as a result? (Choose all that apply) A. Type 1 B. Type 2 C. Type 3 D. Type 4 E. Type 5 Answer: A, B Explanation: Area range command is used for summarizing routes on the boundary of two OSPF areas. The information to be summarized is contained in two types of LSAs: Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 6: Network Management (12

Ensurepass2013 Latest Cisco 350-001 Exam Section 6: Network Management (12 Questions) QUESTION NO: 1 Which types of SNMPv1 messages are sent from the NMS (Network Management Station) using SNMP version 1 to the Agent? A. Trap, Get and Set B. Get, Set and Getnext C. Get, Set, Getnext and GetBulk D. Get, Set and GetBulk E. Trap only Answer: B Explanation: SNMP itself is a simple request/response protocol, and the SNMPv1 operations used by the NMS are defined as below. Get: Allows the NMS to retrieve Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 5: IPv6 (8 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 5: IPv6 (8 Questions) QUESTION NO: 1 What best describes the IPv6 Solicited-node Multicast address? A. For each unicast and anycast addresses configured on an interface of the node or a router, a corresponding solicited-node multicast addresses is automatically enabled. B. The solicited-node multicast address is scoped at the local link. C. Since ARP is not used the in IPv6, the solicited-node multicast addresses is used by nodes and router to learn Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 4: Transport (5 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 4: Transport (5 Questions) QUESTION NO: 1 In your network, you want the ability to send some traffic around less congested links. To do this, you want to bypass the normal routed hop-by-hop paths. What technology should you implement? What should you use? A. Traffic engineering B. Traffic tunneling C. Traffic policing D. Traffic shaping E. Traffic routing Answer: A Explanation: Traffic engineering allows you to bypass the routing protocol information Read more [...]
Uncategorized

2013 Latest Cisco 350-001 Exam Section 3: Applications (6 Questions)

Ensurepass2013 Latest Cisco 350-001 Exam Section 3: Applications (6 Questions) QUESTION NO: 1 With regard to the File Transfer Protocol (FTP), which of the following statements are true? A. FTP always uses one TCP session for both control and data. B. With passive mode FTP, both the control and data TCP sessions are initiated from the client. C. With active mode FTP, the server used the "PORT" command to tell the client on which port it wished to send the data. D. FTP always uses TCP port 20 for Read more [...]