[Free] 2018(Aug) Ensurepass Cisco 300-101 Dumps with VCE and PDF 231-240

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco IP Routing

Question No: 231 – (Topic 7)

Refer to the exhibit. Which interoperability technique implemented on the dual-stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the

2002::/16 prefix?

Ensurepass 2018 PDF and VCE

  1. Dual Stack

  2. NAT-PT

  3. 6to4 tunnel

  4. GRE tunnel

  5. ISATAP tunnel

Answer: C

Question No: 232 – (Topic 7)

When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA?

(Choose two.)

  1. IPv6 address for the host

  2. lifetime of the prefix

  3. prefixes for the link

  4. keepalive timers

  5. request for the local host IP address

  6. any route advertisements it has received

Answer: B,C Explanation:

In IP Version 6, Router Advertisements have the following attributes:

  • Routers advertise periodically

    • Max. time between advertisements can be in the range from 4 and 1800 seconds

    • The advertisement has a lifetime (= 0 if not a default router)

  • Advertisement contains one or more prefixes

    • Prefixes have a lifetime

  • Preferred lifetime

  • Valid lifetime

  • Specifies if stateful or stateless autoconfiguration is to be used

  • Plays a key role in site renumbering

    Question No: 233 – (Topic 7)

    Refer to Exhibit.

    Ensurepass 2018 PDF and VCE

    A network engineer receives a command output from a customer that indicates an issue with NTP. What are two reasons for the output? (choose two)

    1. NTP traffic is blocked.

    2. NTP is not configured.

    3. The router is the NTP master.

    4. ntp update-calendar is missing.

    5. There is an NTP authentication failure.

    Answer: A,E

    Explanation: NTP uses a value, called a stratum value , to indicate the believability of a time source.

    Valid stratum values are in the range 0-15, with a value of 16 being used to indicate that a device does not have its time synchronized. However, Cisco IOS only permits you to

    set stratum values in the range 1-15.

    Source – CCNP Routing and Switching ROUTE 300-101 Official Cert Guide, Kevin Wallace, Page 724

    Question No: 234 – (Topic 7)

    DHCPv6 can obtain configuration parameters from a server through rapid two-way message exchange. Which two steps are involved in this process? (Choose Two)

    1. solicit

    2. advertise

    3. request

    4. auth

    5. reply

    Answer: A,C

    Question No: 235 – (Topic 7)

    Refer to the Exhibit.

    Ensurepass 2018 PDF and VCE

    What is the correct configuration to enable router P4 to exchange RIP routing updates with router P1 but not with router P3?

    1. P4(Config)# interface fa0/0P4(Config-if)# neighbor 192.168.10.3P4(config-if)# passive- interface fa0/0

    2. P4(config)# router ripP4(config-router)#neighbor 192.168.10.3P4(Config- router)#passive-interface fa0/0

    3. P4(config)# interface fa0/0P4(config-if)# neighbor 192.168.10.3P4(config-if)# passive interface192.168.10.34

    4. P4(config)# router ripP4(config-router)# neighbor 162.168.10.34 no broadcastP4(config- router)# passive-interface fa0/0

    Answer: B Explanation:

    When you configure router P1 to be the nieghtobr of P4 with a passive interface, the RIP routing updates will be exchanged with the neighbor only.

    Question No: 236 – (Topic 7)

    A router receives a routing advertisement for the same prefix and subnet from four different routing protocols. Which advertisement is installed in the routing table?

    1. RIP

    2. OSPF

    3. iBGP

    4. EIGRP

    Answer: D

    Question No: 237 – (Topic 7)

    In IPv6, the interfaces running OSPF can be configured with multiple address prefixes.

    Which statement is true about the IPv6 addresses that can be included into the OSPF process?

    1. Specific addresses cannot be selected for importation into the OSPF process.

    2. Specific addresses can be selected using an ACL.

    3. Specific addresses can be selected using a route map.

    4. Specific addresses can be selected using a prefix list.

    Answer: A Explanation:

    http://www.6deploy.eu/workshops/kenya_20080617/IPv6 Routing_OSPFv3_MP- BGP.pdf (slide 20, 3rd bullet)

    Question No: 238 – (Topic 7)

    A network engineer wants to display the statistics of an active tunnel on a DMVPN network. Which command should the administrator execute to accomplish this task?

    1. Router#show crypto ipsec sa

    2. Router#show crypto isakmp peers

    3. Router#show crypto isakmp sa

    4. Router#show crypto ipsec transform-set

    5. Router#show crypto engine connections active

    Answer: A

    Question No: 239 – (Topic 7)

    Which three IP SLA performance metrics can you use to monitor enterprise-class networks? (Choose three.)

    1. PAcket loss

    2. Delay

    3. bandwidth

    4. Connectivity

    5. Reliability

    6. traps

    Answer: A,B,D

    Question No: 240 – (Topic 7)

    Which easy virtual networking configuration component significantly decreases network configuration?

    1. Easy Trunk

    2. dot1e

    3. virtual network trunk

    4. VNET tags

    5. MBGP

    Answer: C

    100% Ensurepass Free Download!
    300-101 PDF
    100% Ensurepass Free Guaranteed!
    300-101 Dumps

    EnsurePass ExamCollection Testking
    Lowest Price Guarantee Yes No No
    Up-to-Dated Yes No No
    Real Questions Yes No No
    Explanation Yes No No
    PDF VCE Yes No No
    Free VCE Simulator Yes No No
    Instant Download Yes No No

  • Leave a Reply

    Your email address will not be published. Required fields are marked *