Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Aug Cisco Official New Released 400-201
100% Free Download! 100% Pass Guaranteed!
CCIE Service Provider Written Exam (V 4.1)
Question No: 141
Refer to the exhibit. A network engineer is troubleshooting a packet over SONET connection between Router A and Router B. What is causing the line protocol to be down?
-
The keepalive must be set on both sides
-
The POS CRC must be set on both sides.
-
There is an encapsulation mismatch
-
There is an MTU mismatch.
Answer: C
Question No: 142
In which way does the DS-Lite IPv6 transitioning mechanism differ from IPv6 Dual-Stack?
-
DS-Lite is a combination of tunnel and translation technologies.
-
DS-Lite is a transition technology that gives full IPv6 connectivity for IPv6 capable hosts that are on the IPv4 Internet but have no native connection to an IPv6 network.
-
DS-Lite is an automatic tunnel where the tunnel destination is determined by the IPv4 address extracted from the IPv6 address that starts with the prefix 2002::/16.
-
DS-Lite is a stateless tunneling mechanism with a lightweight and secure manner without requiring upgrades to existing IPv4 access network infrastructure.
Answer: A
Question No: 143
In an inter-AS L3VPN Option B, the PE-ASBRs use which routing table to store all the VPN routes that need to be exchanged?
-
IGP table
-
BGP table
-
VRP routing table
-
global routing table
Answer: B
Question No: 144
The XYZ service provider network is composed of hundreds of routers that run OSPF and LDP. Which two LDP features can be used to increase peering update performance and reduce local memory consumption? (Choose two)
-
Session protection
-
Specify label range
-
Autoconfig
-
Label allocation control
-
IGP sync
-
Label acceptance control
Answer: D,F
Question No: 145 DRAG DROP
Drag each resiliency mechanism on the left to its corresponding technology on the right.
Answer:
Explanation:
C:\Users\tgt\Desktop\Data\Untitled.jpg
Question No: 146
A customer has a requirements record voice calls for IPT connected on switch A using VLAN 200.Record traffic should be forwarded to the IPCC recording server, which is connected on switch B, voice recording is not working. Assuming that RSPAN source monitoring is properly set, which action fixes this problem?
-
On switch B, the monitor session 1 destination remote
lt;interface_config_to_recording_servergt; command must be applied
-
On switch B, the port connects to the recording server must have an IP address and be accessible via VLAN 200
-
On switch B, the port that connects to the reording server must be accessed on VLAN 200
-
On switch A and switch B, the remote-span command must be configured on the mirroring dedicated VLAN
Answer: D
Question No: 147
Refer to the exhibit. All routers are running Cisco IOS software. Which configuration enables PIM Anycast RP on RP1?
A.
Ip msdp peer 10.1.1.2 anycast loopback1 Ip pim rp-address loopback0
B.
ip msdp peer 10.1.1.2
Ip pim rp-address loopback0
!
Router bgp 10
Neighbor 10.1.1.2 remote-as 10
Neighbor 10.1.1.2 update-source loopback1
!
Address-family ipv4 multicast Neighbor 10.1.1.2 active
C.
ip msdp peer 10.1.1.2 connect-source loopback1 Ip msdp originator-id loopback 1
Ip pim rp-address loopback0
Answer: C
Question No: 148
Which three PIM modes require RP? (Choose three)
-
PIM-DM
-
PIM-SM
-
PIM with mLDP
-
PIM-SSM
-
PIM anycast
-
PIM-BIDIR
Answer: B,E,F
Question No: 149
Which statement about LDP Session Protection and LDP-IGP sync is true?
-
Both LDP features cannot be used at the same time in a MPLS LDP enabled network
-
LDP Session Protection re-exchanges label information when a down-up event occurs; LDP-IGP sync keeps the adjacency and label information in a down-up event
-
LDP-IGP sync re-exchanges label information when a down-up event occurs; LDP Session Protection keeps the adjacency and label information in a down-up event
-
Both LDP features must be used together to increase fast convergence on an MPLS LDP-enabled network
Answer: D
Question No: 150
Two MPLS VPN customers want to acquire Internet access. They make use of overlapping address space but do not want to use NAT on the CPEs. Which action satisfies this requirement?
-
Configure each VRF with a default route in the global table by using a static route toward each customer#39;s range, pointing to the customer interface in the global table.
-
Configure VRF-aware NAT with a default route in the global table for each VRF that requires it
-
Configure a separate PE-CE sub interface that terminates in the global routing table on the PE.
-
Configure the Internet upstream interface inside a VRF, Which becomes an extranet VRF to which customers join and make use of NAT in this VRF.
Answer: A,B
100% Dumps4cert Free Download!
–400-201 PDF
100% Dumps4cert Pass Guaranteed!
–400-201 Dumps
Dumps4cert | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |